If you're here you're interested in wiring up our EM61 VFD into your X-Carve's Controller provided by Inventables, then you're in the right place.

 

Goal:  Wire up our VFD into the X-Carve Controller to allow their controller to control the speed of the spindle motor.

 

Wiring Diagram

Let's start with the wiring diagram... also see attached pdf.

 

VFD Programming

Next there's VFD programming to be considered... 

 

P0003	0	Operation Control Mode A (Run/Stop)
P0004	3	Frequency Source A (RPMs)
P2015	10	Maximum PWM Voltage 0-10v for X-Carve

 

X-Carve's have limited control capabilities. Which means you must hit the "Run" and "Stop" on the VFD's keypad in order to allow their controller to run on command.