You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
IoT Wiring
print icon

There are two things to keep in mind with regards to wiring up your IoT power strip... FM1 and GND.   These two pins output a voltage range and when the motor is >5500rpms, the voltage will be high enough to trigger the Iot.  



Note that if you've followed our "Temporary Addendum" to enable automatic control for your Onefinity with older firmware... then the strip will not be triggered until you're >15,000rpms.

0 out of 0 found this helpful

scroll to top icon